pantin

A tail that bends

The tail is one image on three bones. Made a mesh, its triangles follow each bone by a share, and it bends instead of breaking.

Chapter 4 of 910 minutesSetup mode

A mesh from the outline

  1. Select tail 1 in the tree and choose its piece, tail, in the right panel.
  2. Press Trace outline: pantin follows the edge of the image and cuts what is inside into triangles.
  3. Press Bind to bones: each vertex is shared between the bones near it, here the three bones of the tail. The panel says carried by 3 bones.
The tail chosen, its outline traced into a mesh and bound to the three bones of the tail
Trace the outline, bind to the bones.

Paint the weights

  1. Choose the Weights tool (J), then select tail 3 in the tree: with this tool the mesh stays chosen, and the share of the selected bone is drawn on it.
  2. The tail has few vertices: set the Size of the brush to 90.
  3. Paint over the end of the tail. The share of the bone grows where the brush goes, and the other bones keep the rest in their proportion. A stroke is one undo.
The Weights tool paints the share of tail 3 on the mesh of the tail
The share of tail 3, painted.

See it bend

Choose the Rotate tool (E), select tail 2 and turn it: the tail bends along its bones. Ctrl+Z puts it back.

Tail 2 turned with the Rotate tool: the mesh of the tail bends
The mesh follows its bones.